About the maintenance and cleaning of fur

When the skin becomes wet or damp, put it in a dry place and dry it with a brush. If you have dirt, you must remove it in time. Note that mink coats cannot touch things like cosmetics, cigarettes, oil, salt, etc., especially those liquids, such as perfumes.

q: Do you store fur at home and hang it like ordinary clothes?

a: First of all, depending on the weight of the fur, you have to choose a strong hook and hanger, do not hang the fur on a thin hanger. You need to use a wide shoulder hanger. And make sure that the fur has a certain amount of space in the closet to ensure that it will not be crumpled. In addition, when traveling, it is necessary to place the fur in a cloth coat cover, and plastic or rubber-lined pockets cannot be used because this texture will prevent air circulation and fur breathing.

q: How is the fur cleaned? How about an ordinary dry cleaner?

a: For such a valuable item as fur, you must go to a professional fur cleaning shop to clean it, and do not go to an ordinary dry cleaners. A fur garment must be cleaned every year by fur specialists, dust and stains will be removed during the cleaning process, and the leather will also be rejuvenated under professional oil treatment. Do not attempt to insult the fur without professional guidance, as no family treatment can replace professional cleaning.

q: What if the fur encountered the snow?

a: If your fur is accidentally wetted by snow, shake off the water droplets on the needle and hang it in a well-ventilated room. Do not leave it in an overheated place, such as by a heater. Because this will make the rough and cracked fur surface. After the fur has dried, shake it again. If the fur is completely soaked, it is recommended to go to a specialty shop for professional and proper maintenance.

q: How to save mink coat?

a:Before releasing, must be in the sun for 2-3 hours, and do not direct sunlight, there is a layer of cloth blocking the best, until the heat can be released. There is also the need to clean the surface of the fur coat, not too much dust. The most important thing is to put it in a relatively dry place and take it out when it is wet. Do not get wet.

Car belt repair and maintenance regularly check is the focus

Vehicle maintenance is defined for the belt wear and ageing prevention of automotive engines. The rare root belts are defined at the front of the machine and each belt bears the primary result. On the proposal machine, various types of auxiliary machines are driven via belt drives, such as the shrinking machines for air conditioners, power steering pumps, and alternators. Assuming that the belt is broken, slippage may occur, which will cause the related auxiliary engine to lose its function or reduce its function, and then affect the normal operation of the car.

The belt reflection method is very simple. First, introspect the tension of the belt. At this time, you can use the thumb to strongly press the belt between the two pulleys. The pressing force is about 10 kg. Assuming that the belt is about 10 mm in depression, it is considered that the belt tension is appropriate. Assuming that the amount of reduction is excessive, the tension of the belt is considered to be insufficient. Assuming that there is almost no reduction in the belt, the tension of the belt is considered excessive. In the absence of tension, the belt is slippery. When the tension is too large, it is very easy to damage the bearings of various auxiliary machines. For this purpose, the relevant adjusting nuts or bolts should be loosened and the tension of the belt should be adjusted to the optimum shape.

In addition, car maintenance must also pay attention to the wear of the belt. Old belts are worn out and the contact area between belts and pulleys is drastically reduced. At this time, just press the belt with force and the belt sinks deep into the groove of the pulley. The belt rubber also has an aging problem. Assuming that the belt rubber is seriously aged, the new belt must be changed in time.

The car engine is the brain of the car. If the engine is bad, it means that a car is useless. When a car is running on the road every day, if it takes a long time, it may cause the engine belt to wear out or deteriorate. Therefore, the owner usually starts to inspect the belt for a while to avoid unnecessary troubles.